mjk
Titanium
- Joined
- Oct 20, 2005
- Location
- Wilmington DE USA
making a couple shafts out of 6061 and 7075 on an older vmc Omb control
new 1/2" 3flt from Frank
3 jaw chuck holding 3/4" material in vertical position
Detail is lowest diam .65, next level .57 cam profile, top .435 total length of cuts 1.5"
I can hold the diameters and good finish
Final exit point leaves a small unmeasurable vertical line
part will probably be accepted but would like to improve.
Currently leaving diameter from G2 to a small G1 away from radius move before canceling G41
Not looking to spend hours tweaking ballscrew issues etc
Looking for suggested good practice to add/modify code
if it wasn't for the cam I'd pop them out on the lathe
new 1/2" 3flt from Frank
3 jaw chuck holding 3/4" material in vertical position
Detail is lowest diam .65, next level .57 cam profile, top .435 total length of cuts 1.5"
I can hold the diameters and good finish
Final exit point leaves a small unmeasurable vertical line
part will probably be accepted but would like to improve.
Currently leaving diameter from G2 to a small G1 away from radius move before canceling G41
Not looking to spend hours tweaking ballscrew issues etc
Looking for suggested good practice to add/modify code
if it wasn't for the cam I'd pop them out on the lathe