Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Largest Manufacturing Technology Community on the Web
Stay Connected:
13engines's latest activity
-
113engines replied to the thread External M Code Mori NL2000.I don't think the OP realizes how lucky he has it to have a Spare M Code Option installed. The connection points for all the spare M...
-
1I have done similar when retrofitting a probe to machines that did not have logic specific to a probe interface. Many builders include...
-
113engines replied to the thread The Ultimate Coolant Ring.Although one programmable coolant nozzle does about everything a person could ask for, two programmable nozzles fills in all the blanks...
-
113engines replied to the thread External M Code Mori NL2000.That did cross my mind at one point. If he had a pair of M codes at his disposal, he might be able to do like I did in a Probe On/Off...
-
113engines replied to the thread External M Code Mori NL2000.If a FIN signal was needed, you would want a 24VDC connection to one post of a NO switch mounted or integral to the Pump Motor Start...
-
113engines replied to the thread New lathe, in need of 3 phase!.Yes just get a 7 1/2 or 10HP Rotary Phase Convertor and be done with it. Will offer a little room to grow too when needed. If you're...
-
113engines replied to the thread CNC Lathe - Setting Y value of cutter.This may be obvious from what sinha offered, but what he's showing only applies to tools with the shank width that the turret was built...
-
113engines replied to the thread Foaming Issues in VMC Machine.Did you use DI/RO water or similar for initial fill? In most case, initial fills should be with tap water. At least the the bulk of it...
-
1Easy. We have a newbie who is very unfamiliar with CNCs.
-
113engines replied to the thread How much could I lift?.Sorta OT, but unless you're looking to butcher a deer, I can't see where a stationary lift is of much value. Anything you lift can only...
-
113engines replied to the thread Work co ordinate setup.Curious how this thread about Work Coordinates drifted into talk of Absolute/Incremental, when they have absolutely nothing to do with...
-
113engines replied to the thread Fanuc O-T C lathe parameters for controlling spindle accel/ decell.On a hunch I just pulled out my Fanuc Alpha Series Spindle Motor Parameter Manual. Mostly what it did was reminded me how much goes on...
-
113engines reacted to Garwood's post in the thread Thinking of getting a CNC machine and have some questions with
Like.
I suggest a Makino A77 as it would would meet your requirements nicely. -
113engines replied to the thread Fanuc O-T C lathe parameters for controlling spindle accel/ decell.BTW... what you;'re looking for might be referred to as a Time Constant. If you can't find anything in the parameter manual, you might...
-
113engines replied to the thread Fanuc O-T C lathe parameters for controlling spindle accel/ decell.Just about every Fanuc Manual ever printed is available free on the www. The one good thing about downloading one is now you have a...