What model L & S lathe do you have? There's five different models they made over the years. If it is a Model X or a power turn, there is a manual on Vintage Machinery that may help you on setting the QC gear box to the correct thread pitch. Coming out of the gear box, you have to shift the...
Talking about chopping up a lathe bed or any other machine member into a straight edge. My dad made a straight edge about 18" long that was cut out of a machine member when I was in diapers. Later in life I got ahold of the straight edge and tried to scrape on it. Dad never did stress relieve...
What a nice find! And appears to be in very nice condition.
I have a 14" Rockwell lathe that was pretty butchard up when I got it. Luckly the bed was in nice shape. I rebuilt most of the lathe and so far has turned into a nice lathe.
There's a good chance they mounted it on a non-bridgeport type of machine that had a different taper in the spindle. Did you by chance mic the id of the regester to make sure it is 3.375"? And didn't get re-bored for a different OD quill by chance?
My Bridgeport RA head, I use it on my Index...
"Warning: some - all? - of these CY lathes couldn't directly cut an 11.5 TPI thread for NPT 1-2"...but perhaps 2.25mm is close enough when we're talking a taper thread? I don't know as I've never investigated this with actual pressure testing (maybe someone can speak to this?). "
Won't work...
Here's a couple of sources closer to your area that may be able to serve you better than the other source. https://www.reevesgaugeandtool.com/index.html
Also these guys, https://www.swgage.com/
It's your call.
I don't get involved with the tubular side of the industry. I deal with the stuff...
I think the hole is going to be a little squirrely and not straight when done. Heat shrink the liner in place. Then expect the bullet to shoot out straight and hit the target?
Pm me and I'll fix you up with a more detailed drawing of the thread with dimensions that A.P.I. does not show you in 5B that may help you. I don't have any programming resources available to help you out. I know of one outfit that used to cut the 8 and 10 RD in four passes! Yikes!
"Does this profile have any nuances or is it about like ACME?"
It is a full profile form thread. There cannot be any breakdown in the form.
Yes, it does require a gage to get the proper stand off and be consistent with industry that cuts the threads. Yes, there are shops out there that will...
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.