Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Largest Manufacturing Technology Community on the Web
Stay Connected:
angelw's latest activity
-
Aangelw replied to the thread Straight compensation for turning on Fanuc 32i.Yes. I suspect that the Offset adjustment would follow as to whether the control was set for Diameter or Radius programming via Setting...
-
Aangelw replied to the thread Variable macro / Tool life management seeing each other.Purely on a count per tool operation that would work, but unless the OP's control can access a Variable or Parameter to determine the...
-
Aangelw replied to the thread Work co ordinate setup.Hello rj, Yes, it's only redundant until you have a situation like the OP, where the Work Shift Offset is set to the default Offset when...
-
Aangelw replied to the thread Work co ordinate setup.I suspect that you continue the program from the start of a Tool Operation, rather than in the middle of machining part of the Tool...
-
Aangelw replied to the thread Error RS232C_2.As Kevin suggests, that's a band aid fix at best. Slow the baud rate down enough and the program can be sent successful with no...
-
Aangelw replied to the thread G12.1 on a Mori Seki Wont do a Radius....With all due respect, based on the program you listed in your earlier Post, you either need to get a decent Post Processor for CAM...
-
Aangelw replied to the thread Error RS232C_2.Buffer Overflow is rather uncommon when just transferring a program from an external device to the Control Memory, if settings at the...
-
Aangelw replied to the thread Error RS232C_2.It's the reaction of the External device UART that can cause the Buffer Overflow at the control when Software Handshaking is being used...
-
Aangelw replied to the thread Error RS232C_2.There are two types of Handshake available, Software (Xon Xoff) and Hardware. Having the wrong Handshake Method set at the control, or...
-
Aangelw replied to the thread Macro Programming Fundamentals.Hello Moriseikiman, Most of your messages in the Message Blocks, contain more that 26 characters, including spaces, therefore, will be...
-
Aangelw replied to the thread Tooling for a 1/2"-5 Acme double start internal thread 1.25" long.Hello Marcus, Yes, I've had a brain fog moment. For some inexplicable reason I took the 10 and 5 as mm, rather than TPI. Accordingly, 5...
-
Aangelw replied to the thread Tooling for a 1/2"-5 Acme double start internal thread 1.25" long.For clarity for those reading that don't know much about multi start threads, you have your terms arse about. The Pitch of a Tread is...
-
Aangelw replied to the thread Okuma LB15 stuck chuck on spindle taper.The method of using the Draw Tube to push the chuck loose normally works, but you need to screw the draw tube back to being fully...
-
Aangelw replied to the thread Help with a Lathe tapping cycle.As suggested by Ox, but also delete G97 S85 M03, M29 S85 and the Tapping Cycle will start the spindle. It depends on the implementation...
-
Aangelw replied to the thread Boring Head Pullout.Hello Painkeeper, There are quite a few Canned Cycles for boring, but in particular for accurate bores, G85 cycle will will feed in to...