What's new

Recent content by BengtFP1

  1. B

    FP1 rapid traverse not working

    Quick follow up on this one. I tested the active feature as suggested by AlfaGTA. By simply pressing the orange buttons for incremental and absolute positioning the rapids came back to life! Not sure if this is a bug or a feature? In any case the rapid works fine in manual mode now (same DRO...
  2. B

    FP1 rapid traverse not working

    Thank you for getting back to me. Much appreciated! I agree my videography has room for some improvement. Will see if I can make a better video by dimming the shoplights and aim the camera at the DRO/console buttons. Normally I don't use the incremental or absolute automatic positioning. I...
  3. B

    FP1 rapid traverse not working

    I brought home a Deckel FP1 last year. Nice machine - well maintained and little wear. The only issue is the rapid traverse. It will only move an inch or so before it abruptly stops (see video below). This affects the traverse on all axis. The power feed works fine at max speed 500 mm/min. I...
Back
Top