Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Largest Manufacturing Technology Community on the Web
Stay Connected:
Billy_C's latest activity
-
BAre all the leveling feet touching the floor.
-
BBilly_C replied to the thread Hass Mill tool probing (VPS) question.Don’t see why you would need a diameter unless you wanted to do in process tool checks. How are you programming? Are you trying to use...
-
BBilly_C replied to the thread Machine Tool Monitoring.There is a short thread there that’s sparse on info but could get you started...
-
BBilly_C replied to the thread Machine Tool Monitoring.There is an open source Fanuc driver software to pull and convert data from Focas to MQTT (and other formats). Once it’s in a more...
-
BBilly_C replied to the thread How to move a stuck ATC?.There should be a too change recovery procedure setup by Sharp. Unfamiliar with that specific machine but usually it’s something like a...
-
BBilly_C replied to the thread new to 5 axis question.Also, fanuc told me dynamic fixture offset doesn't need to be programmed to cor, it uses kinematic parameters just like tilted work...
-
BBilly_C replied to the thread new to 5 axis question.And then there is g54.4 which is error correction something or other. 4 axis, 5 axis… doesn’t need to program to centers of rotation...
-
BBilly_C replied to the thread new to 5 axis question.Tilted work plane vs dynamic fixture offset. (Both fanuc options for rotary positioning) What is the difference and when should you use...
-
BBilly_C replied to the thread new to 5 axis question.I've seen this as well. Seems a lot of replies here take for granted the cam -> post processor workflow that "just works". When it...
-
BBilly_C replied to the thread new to 5 axis question.same thing, either doesn't have it or don't know how to use it/get cam to output it. It's not that rare for shops to just lack the...
-
BBilly_C replied to the thread new to 5 axis question.Programming to the centers of rotation eliminates the need for any types of dynamic offsets or tcpc to even be called at all. Most of...
-
BBilly_C replied to the thread new to 5 axis question.Been in some modern shops that still do it this way. Not the best way to do it anymore but I guess it still works for some people.
-
BBilly_C replied to the thread What's everyone's preferred method of verifying 5 axis kinematic rotation point?.I will have to read through your post a few times to fully get it but on first glance… Focusing only on “z”…. it’s important that the...
-
BBilly_C replied to the thread What's everyone's preferred method of verifying 5 axis kinematic rotation point?.is this all referring specifically to brothers and the latest control? Also, is the pitch compensation you are referring to for linear...
-
BBilly_C replied to the thread Mist Collector for Brothers.Also, the Amano MZ-15 is not really that great, even spec wise. Filtration down to 2 micron, HEPA is something like half a micron I...
