Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Largest Manufacturing Technology Community on the Web
Stay Connected:
chad883's latest activity
-
Cchad883 replied to the thread Need help with C-axis milling feedrate.Sounds like it is hitting the max feed rate setting in the parameters. Not sure what parameter that would be, but worth a look.
-
Cchad883 replied to the thread Moving an Integrex 100sy.I am pretty happy with it. Worst part is the 1.625 ish bar limit. I bought a new actuator that is bigger and made a new draw tube and...
-
Cchad883 replied to the thread Moving an Integrex 100sy.Would have to pull the guards off the back and main spindle side. Would probably still be too big with tool changer, but that already...
-
Cchad883 replied to the thread Moving an Integrex 100sy.Our 2002 Integrex 100-IISY is at 8'6" over the tool changer. We have the 40 tool changer that travels with the Z carriage. With the head...
-
Cchad883 replied to the thread Nakamura w/18i /Block Skip.On my Citizens I have: M8 /M98P8000 M9 I think the M8 is checking the condition of the loader, if it is not ready to load a new bar it...
-
Cchad883 replied to the thread Mamma's don't let yer babies drive forklifts.I was 10 when I mowed fairways at a golf course. Had to duck tape a 4x4 to the clutch so I could push it in far enough. It was a 13 gang...
-
Cchad883 replied to the thread G12.1 on a Mori Seki Wont do a Radius....To mill outside with G42 in polar is conventional milling, I think. If that is correct, you need G3 not G2.
-
Cchad883 replied to the thread G12.1 on a Mori Seki Wont do a Radius....I hope it is just a typo, but no G1 after G2 move.