What's new

Recent content by csharp

  1. csharp

    Doosan DNM5700 (2016) Message

    LOL, they got back to me. Gave me the info for the local support rep.
  2. csharp

    Doosan DNM5700 (2016) Message

    I called, they took all my info and said they would get back to me.
  3. csharp

    Doosan DNM5700 (2016) Message

    Thanks to all. I have called my service dealer rep with no response yet.
  4. csharp

    Doosan DNM5700 (2016) Message

    Yes it was. I am not getting any of the axis errors either that I would have expected if control power was not on. Isn't there a separate battery for the memory?
  5. csharp

    Doosan DNM5700 (2016) Message

    We replaced the 4 D cell batteries in the mill this morning after receiving the 307 alarm and a low battery alarm. Once we restarted the mill we check the messages and the following message was present. "2199 Check the EOP ROM files". Does anyone know what this means? It may have always...
  6. csharp

    Renishaw protected move feedrate

    When we got our doosan it was also very slow. We make protected position moves at 120ipm now. I believe we got that number from Doosan. Obviously the actual moves for contact are much slower. I think it was originally 60ipm which was much slower that our HAAS and when Doosan told me we...
  7. csharp

    OT Engineering Forum

    Thanks I will check them out.
  8. csharp

    OT Engineering Forum

    Does anyone have any recommendations on a engineering sight similar to PM? I have found eng-tips and engineers edge? Are they any good? Any other recommendations?
  9. csharp

    VFD and Motor Source

    Thank you, unfortunately I only have 208v I will check those places out.
  10. csharp

    Doosan DNM5700 -Used Rotary Install

    Thanks to everyone, after speaking with Koma it sounds like more headache than it is worth. Then what does 4th axis ready mean?
  11. csharp

    VFD and Motor Source

    I am looking to build a machine to spin cast Babbitt. I am looking for a good source for a VFD and motor. I am thinking a 3hp would be all I would need power wise. Top speed I need to spin would be around 1700rpm.
  12. csharp

    Doosan DNM5700 -Used Rotary Install

    I am not sure I was under the impression when I bought it that it was prepped for 4th axis. I asked and they said I still need the drive and wiring that it is 4 th axis capable. If I buy a used one where would I get the drive? Controll is a Fanuc Oi-MF date of manufacture on machine is 8-2016
  13. csharp

    Doosan DNM5700 -Used Rotary Install

    I see some used TSUDAKOMA rotary tables for sale. Can I do the complete install myself? Do I need Doosan to come in an step up some parameters? What about Renishaw probing macros for 4axis? Thanks Lonnie
  14. csharp

    G68 Rotation programming concerns

    Thanks again for the help. I was able to speak directly with a Renishaw rep. He explained that if I run through RenGUI that it is a compiled system and does not use the 500 variables. They also indicated if I use the M165 calls instead of the G65 calls they compiled system is also called and...
  15. csharp

    G68 Rotation programming concerns

    Thank you all for the help. I am reading through our inspection plus manual for Fanuc(Doosan). It does appear that the #501,#502 etc... are used or xradii, yradii ect.... I have not found where it states what range of variables that renishaw uses. I want to pick some outside of the ones...
Back
Top