Hi Eric,
I saw that in 2014 you purchased a Doosan Lynx. I'm in the same position you were in. I currently own a TL2 and have outgrown its capabilities. I'm currently looking at a Lynx MYC (I run one part that is 2.45" in dia) and needs to be put through the spindle or I would have went with the "A" version.
So after owning the machine what are your thoughts and any advice on options? How was the transition from the Haas control to Fanuc? Does Fanuc allow local sub programs like the Haas? Are you using a part probe? Any advice/opinions greatly appreciated.
R,
John
I saw that in 2014 you purchased a Doosan Lynx. I'm in the same position you were in. I currently own a TL2 and have outgrown its capabilities. I'm currently looking at a Lynx MYC (I run one part that is 2.45" in dia) and needs to be put through the spindle or I would have went with the "A" version.
So after owning the machine what are your thoughts and any advice on options? How was the transition from the Haas control to Fanuc? Does Fanuc allow local sub programs like the Haas? Are you using a part probe? Any advice/opinions greatly appreciated.
R,
John