Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Largest Manufacturing Technology Community on the Web
Stay Connected:
Recent content by jhearons
-
J
Swiss sub spindle OD turning holder
You can get a shank and head for the ISO insert of your choice from Utilis.- jhearons
- Post #5
- Forum: CNC Machining
-
J
Small stainless parts, small endmills -- HSM/trochoidal still the way to go, or maybe a segmented rougher?
Can you draw a 2D stock that includes the holes and see if that behaves differently?- jhearons
- Post #28
- Forum: CNC Machining
-
J
Small stainless parts, small endmills -- HSM/trochoidal still the way to go, or maybe a segmented rougher?
Have you considered drilling out the bulk of the slots?- jhearons
- Post #25
- Forum: CNC Machining
-
J
Eccentric live milling on LB3000 help
Make sure you are in the correct plane. -
J
Second operation cnc or plc lathe
That was supposed to say Wasino…- jhearons
- Post #11
- Forum: CNC Machining
-
J
Introduction / Cobot machine tending how-to video recommendations?
So if I put one of the guys on the floor in a black full coverage bodysuit, he will work at a steady pace without breaks and never take a day off?- jhearons
- Post #13
- Forum: Robots and Automation
-
J
Introduction / Cobot machine tending how-to video recommendations?
The biggest hurdle, in my opinion, is a salesperson telling you how easy it is to integrate the robot but refusing (or being unable) to tell you how. Then when you speak to an integrator, they want to charge $150k to set up a collaborative robot you already own to load a lathe. Later on...- jhearons
- Post #8
- Forum: Robots and Automation
-
J
Pricing on a part...I lost my time logs.
Because that would not be correct for that model year.- jhearons
- Post #12
- Forum: CNC Machining
-
J
FS: Johnson tri-roll C3 #1 digital thread gage with M14*1.5 rolls and a bunch of metric thread setting gages $220 shipped
Ok, I give up. I’ll take it. Can we work out payment details tomorrow?- jhearons
- Post #6
- Forum: Tooling, Parts and Accessories For Sale or Wanted
-
J
Okuma M660V- Setting tool length offsets
My bad, I didn’t mean to say “H0”. Should have been “Hx” with “x” representing the 1-99 H value. -
J
Okuma M660V- Setting tool length offsets
When you use positive TLO, the location of the work coordinate Z0 relative to the spindle face must be known. -
J
Okuma M660V- Setting tool length offsets
One thing that needs to be understood when working with the Mx60 mills is that machine home position is not the X+Y+Z+ corner of travel. It is X center, Y center of the table at a point in Z that is above the table. -
J
Okuma M660V- Setting tool length offsets
G15H1 through G15H99 do correspond to G54 etc. G56 H1 etc would be the equivalent of G43 H1. Your machine should be able to use G54 HA which would be calling the A tool length offset for the tool that is in the spindle. There are A, B, and C offsets for tool length and cutter comp. If your...