Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Largest Manufacturing Technology Community on the Web
Stay Connected:
kineticmx's latest activity
-
Kkineticmx replied to the thread Any multitasking mill-turn machine with lower turret below $400k?.This is just my best educated guess: typically a turret index is much faster than a tool change, so faster cycle times would be the...
-
KYour carbide breaks when you know what you're doing ... Mine in first twenty seconds of use:
-
KIf you use a UV cured epoxy you can save a lot of hassle with sagging. Hard to see why you need a 3 axis cartesian robot for 100...
-
Kkineticmx replied to the thread Steel / Stainless roughers for older machines with flood coolant and traditional paths?.One of my biggest findings with air blast is chip evacuation. No, it doesn't have lubricity, no it doesn't have much cooling capacity...
-
Kkineticmx replied to the thread Fanuc Welding servo positioner headstock.Very good point, no I don't need continuous rotation. Welding cable through the back it is.
-
Kkineticmx reacted to Garwood's post in the thread Fanuc Welding servo positioner headstock with
Like.
Do you need to run more than 360 degrees at once? If not, then you don't need brushes. Run a welding cable through the hole and unwind... -
Kkineticmx reacted to LOTT's post in the thread Introduction / Cobot machine tending how-to video recommendations? with Like.
Take a machine that is not set up for automation, and add a robot. Keep it basic, either loading stock onto an air vise for first op on...
-
Kkineticmx replied to the thread Fanuc Welding servo positioner headstock.This is the one I'm eying. It is roller bearing, but so long as I get a good ground I'm not too worried. And it is hollow so I can pass...
-
Kkineticmx reacted to Strostkovy's post in the thread Fanuc Welding servo positioner headstock with Like.
I'd be more comfortable with a brass slipring for low speed high current. Robots often use fancier welding power supplies with more...
-
Kkineticmx replied to the thread Fanuc Welding servo positioner headstock.There are almost no Fanuc headstocks for sale used, typically packaged with robots. Not paying 8k for a welding headstock. Hence my...
-
KThe bean counters have value engineered, and the marketing dept over internet connected any modern appliance. Mechanical switches and...
-
Kkineticmx replied to the thread Fanuc Welding servo positioner headstock.This guy is a spambot posting an AI response right?
-
KI'm looking for a small headstock for a fanuc welding cell. Its a small Arcmate 50 and all the headstocks I am finding are way too big...
-
Kkineticmx replied to the thread May be a "cheap" option to try out some light automation with a robot.I see these available from overseas all the time, how is the UI and programming on them? any personal experience? With fanuc tech...
-
KUpdate, The bolt was seized in the chuck so we had to spin the whole chuck around to remove it......