Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Largest Manufacturing Technology Community on the Web
Stay Connected:
kitno455's latest activity
-
Kkitno455 replied to the thread Cross Slide TPI.Note that the thread is left hand.
-
Kkitno455 replied to the thread New to me South Bend.Hmm, the problem was then not failing to switch the wires, the problem was bypassing the centrifugal switch, or the switch being bad...
-
Kkitno455 replied to the thread New to me South Bend.Cad- I think your wiring diagram leaves L2 always connected to T1, which is fine as long as you have (and use) another means of...
-
Kkitno455 replied to the thread New to me South Bend.Cad- I am sorry, are you saying the diagram I provided damaged your motor? What were the symptoms? Do you have pictures of the wiring at...
-
Kkitno455 replied to the thread New to me South Bend.'T' is typical nomenclature for terminal, though these are often just simple wires on the motor side. You will have to extend 5, 8 and 1...
-
Kkitno455 replied to the thread Antique South Bend with 1-9/16 spindle.What is the thread pitch? Most small SBs are 1.5x8, you could just open one of those up just a touch if the pitch is the same...
-
Kkitno455 replied to the thread New to me South Bend.When a dual voltage motor is run in high voltage mode, the two run windings must be placed in series, that happens at the 2+3 junction...
-
Kkitno455 replied to the thread New to me South Bend.So here's a way to wire it- modify the jumpers on the switch to be 'L' shaped (blue wires), and bring the line from the wall into the...
-
-
Kkitno455 replied to the thread New to me South Bend.That is a standard 3 pole, double throw switch, with jumper wires pre-installed. You can rewire some of those jumpers and make this...
-
Kkitno455 replied to the thread South bend Chipmaster II.there is a south bend forum here- Ted might see it if you post there, and have a manual.
-
Kkitno455 replied to the thread New to me South Bend.Post an image of the wiring diagram of both the motor and the switch (there is usually something inside the cover). We should be able to...
-
Kkitno455 replied to the thread Anybody identify this interesting lathe?.I like the balance weights on the hanging faceplate. I assume that was used on the outboard end of the lathe, though I would expect to...
-
Kkitno455 replied to the thread Want to cut metric threads on SB 13.You should setup the gearbox (and the sliding gear) to cut whatever imperial pitch I gave in the table, per the chart on the front of...
-
Kkitno455 replied to the thread had cataract surgery- going crazy!.You got three eyes? Isn't English a wonderful language :)
