Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Largest Manufacturing Technology Community on the Web
Stay Connected:
Lanza's latest activity
-
LSame here, large diameter boring heads, and a few smaller tools but not spinning too quick because of the materials being cut... All...
-
LI honestly can't remember. But I milled pockets so that it was a "no shake" fit and also have screws holding it in place.
-
LI don't think so, that was back in the pre-phone-camera era. I might though, I'll take a look.
-
LLanza replied to the thread Sandvik Cartridge CA tooling.Sounds good, what type of cartridge did you use? CA type?
-
LLanza replied to the thread Sandvik Cartridge CA tooling.That sounds nice, do you have any photos?
-
LI was thinking of using the Sandvik CA type cartridge on a disc type fly cutter. Just wondering if anyone on here has done the same. It...
-
-
LLanza posted the thread Colchester Mastiff. Mascott Coolant tanks, rusting, replacement, sealing. in General.I currently doing some work on my Colchester Mastiff and I have the oil tank out. This machine has a dry sump and the pump sucks it up...
-
-
LLanza replied to the thread Waldown 7" Bench Grinder with the side tool rest.Yes I get your point, they have been using type 5 on the grinders forever. No one else has said they don't use this type of wheel. Bordo...
