Hi,
I am training to make feature using Esprit CAM for an impeller bladed I am able to select the upper and lower chains but how to select the content line in match lines? How to create a segment for that?
Thanks,
I plan to have a new shrink-fit device for heating the shrink fit holders.
what need to be considered while ordering it?
what do you think about Easyshrink Evo from SECO?
any recommendations?
thanks ...
means it will use the value to do calculations when B is 0 to be the right picture. Is this applicable while MAZATRAOL programming only or it is including EIA/ISO as well?
So is it ok to assign the tool as 45 Deg. tool, then take the offset using probe while B is 45 deg. so in this situation if I run the tool with B0 the tool X will be at edge of radius to angle as the machine adjusting that?
No need to take the offset while the tool is in 0 deg.
Note that the...
I am wondering if I have a neutral tuning tool (VNMG for example) and use tool probe in Integrex to measure A and B in tool data (tool set as 45 Deg. while measuring). if I wish to run the tool on 0 degree, how do I set the tool in the CAM software should I consider if the tool run with 0 deg...
I have never used the high-pressure coolant before, anyway we have one machine that includes high pressure-coolant pump we run M 131 M100 to 106 to control the pressure. I plan to use the high-pressure while drilling.
As first time we use it.
Is there anything related to safety need to be...
I am using a carbide drill on 4130 material with high feed and speed, everything is ok and the chips are flying away, but with that we still use a peck drill cycle
1- I am wondering does the peck has any benefits while drilling by carbide?
2- Will the peck cycle hurt the tip of the drill...
Thanks,
I meant if I install the boring bar inside a socket where the socket is mounted on the turret, this boring bar needs to be flat so it can be hold with the screw?
PITA you mean like easyfix from Sandvik ?
Hi
1- What is the difference between boring bar with flats and the cylindrical one?
2- If I use CNC turning tool where I mount the boring bar using socket the boring bar should be with flats?
Thanks.
I want to use P9814 cycle to measure the ID not for updating the work offset. If the cycle was done, where can I find the value of the measured ID in Mazak controller?
Thanks...
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.