Largest Manufacturing Technology Community on the Web
Stay Connected:
markp's latest activity
-
Mmarkp replied to the thread Moving a Hexagon Optiv 2 Reference 2Z443 CMM.Hexagon wouldn’t tell me anything about shipping preparation. they wanted me to get a service contract and pay them to move it for me...
-
Mmarkp replied to the thread Moving a Hexagon Optiv 2 Reference 2Z443 CMM.Well, here's what I ended up doing. Locked the two z axis by bolting alum plates from the lower frame to the bearing trucks. (I just...
-
-
MIm moving a Hexagon Optiv 2 Reference 2Z443 CMM tomorrow. I don't have the manual for transportation but the OP manual I do have...
-
-
Mmarkp replied to the thread 2000 DMU50V Millplus won't get past I01 initialization.As of today, if I start the machine, it will stay running for about 5 min if I dont move anything. If I reference and run a warmup...
-
Mmarkp replied to the thread 2000 DMU50V Millplus won't get past I01 initialization.Im guessing it needs to have the caps replaced on either the output module, a bad IGBT, (ordered a new one), or bad caps on the DDC2...
-
Mmarkp posted the thread Swapping Heidenhain DDC2 drive controllers to test - Simodrive 611 in CNC Machining.Im trying to troubleshoot a simodrive 611 with Hiedenhain DDC2 optical drive controllers. I want to swap the DDC2 modules to see if the...
-
Mmarkp replied to the thread 2000 DMU50V Millplus won't get past I01 initialization.Replaced the 16K31 contractor in the cabinet. One of three that controls the safety circuit. A used contractor but tested good. Started...
-
Mmarkp replied to the thread 2000 DMU50V Millplus won't get past I01 initialization.So Im still getting X 053+ errors once and a while. I think its the X axis servo section failing. The error is "Drive not responding"...
-
Mmarkp posted the thread Ok to mix rev version on Siemens simodrive Lt module 25 amp 6SN1123-1AA00-0BA0? in CNC Machining.Is it ok to mix rev versions on these drives? I see lots of rev A versions for sale on the used market but few version C. Im replacing a...
-
Mmarkp posted the thread 2000 DMU50V Millplus won't get past I01 initialization in DMG MORI, Gildemeister, Maho CNC.Want to run a job today and the door safety switch started acting up. It does this once and a while and I just do a soft reset and...
