There is a flatness requirement so I guess lapping is not an option here. We have special totes for moving machined product to our de-greasing/cleaning station, therefore residue on the surface is not a problem.
Hello
We machine SS which need mirror finish, so far this has been done manually with an operator holding each piece against a polishing wheel. The parts are at most 5"x3" and .500" thick. The problem is this very inefficient,tiring and everyone hates doing it.
So I am looking for an...
we are specifying .015-.030 inches deep. the main challenge is the parts wear faster than we anticipated, so the idea is that getting a naturally more wear resistant material should help with this problem.
hello,
we currently heat treat 1214 to about 40HRc in order to improve its wear resistance. we would now like to make a cheaper production by replacing this with material that does not require heat treating but has same or better wear resistance as 1214 heat treated to Hrc 40,
any suggestions...
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.