Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Largest Manufacturing Technology Community on the Web
Stay Connected:
Milling man's latest activity
-
MMilling man replied to the thread Any multitasking mill-turn machine with lower turret below $400k?.:rolleyes5: Maybe WFL? Seems they have a turret option on the smaller models (small for WFL haha) and they are in Austria which will...
-
MHave you seen this PDF? Very useful. It has lots of info on probe details along with the compatible Tesa, B&S and Mercer probes.
-
MYou mention the use of a file. You should be focusing on taking everything possible away from your low level employees. EG: Deburr...
-
MI have said this many times, but I will say it again- since about 1988, I have been hiring employees who are just finished getting 2...
-
MWe tested software from Hexagon a while back which uses this concept. You pick the measurement points on a 3d model, then the software...
-
MI do on machine probing all the time with the Hermle and Heidenhain control. I program the points within Powermill, after that I import...
-
MMilling man replied to the thread 3d probing on machine.Yes, for now it's just out of curiosity. Several times in my life I had to solve similar problems, and I did it without tricks -...
-
MNo secret, but it was a long time ago and I did not move it to subscription so I am stuck 2018 release. However that's fine as autodesk...
-
MMilling man replied to the thread 3d probing on machine.Oh, this is wonderful! If it's not a secret, how much did this program cost?
-
MThat's typically how simple raster probing works - when you have a 2d or 3d line/sheet of points that were all probed with the same...
-
MMilling man replied to the thread 3d probing on machine.Why not? You can first take a rough measurement and then re-measure the part based on the first result. This will reduce the error to...
-
MThis can be done with Renishaw Productivity+. There's a stand-alone version, as well as a version that's built into Mastercam...
-
MMilling man replied to the thread 3d probing on machine.I think usually the situation is a little different. We processed the part on the machine, and we know its shape quite accurately. But...
-
MThe problem in 3d probing is, that in order to define the probe approach trajectory (which must be normal to hit surface) one must know...
-
MMilling man reacted to EPAIII's post in the thread How to read metric abbreviation for level vial sensitivity. 20"/2mm with
Like.
I think the author of the Wikipedia article you link to was a bit misleading in saying the radian is a SI unit. The SI units are all...