Hi Mel,
Issue with the surge protector is due to bypassing the start switch in the motor - the below schematic will work on your setup. if the rotation and the switch handle position are not as you wish, swap wires 3 & 4 on the switch to flip the relationship ( Follow the colored arrows to...
Hello Mel,
Please review the below sketch - note that your surge protector was tripping due to the bypassing of the start switch in the motor - the below layout will allow you to hook up and run the motor - if the switch position is not the way you wish - reverse the connections of wire red /...
If you don't have a solution yet, look at the attached - best way is to sketch entire circuit so you can check electrical flow direction. key is that their is a shift from start and run to change direction....red is one way - lime is the other - this is very simple when all points are shown,
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.