Very good plan. If you are modifying the engine to increase output, look at moving peak torque to a higher rpm. Even if a different camshaft or what ever. Maybe propane injection, increasing spray pressure, etc.
Maybe a small amount of stress there, not enough to concern. Provided the threaded portion of the stud is about the same as the orginal cap screw. SAE specifications state the length of the threaded portion of the threads for each size cap screw/bolt. The thickness of the block's web has...
Rule: Failure occurs where local stress exceeds local strengh.
I am not seeing a strong coorolation between the cracked block and the fastening system. I do see a decreased capacity in the system by the modifications. If you want studs, the block engagement threads should be aproximately...
Well, sounds more like studs since it is threaded on both ends. Steam turbine studs are heated to a specific value, installed in the lower case then the top nut is threaded hand tight and allowed to cool. I have installed Super nuts on studs 2 inch diameter and 18 inches long. The multi bolt...
Thanks for your assistance, it helped me form a recommendation. I had the goal of presenting,to the owner, to proposal yesterday. I had a motor with analog speed control that i had removed from a labotory press that was a quick solution to the situation. I am leaving the orginal motor and...
Thanks for responding. I failed to put the correct number in. P30001 it is. And Yes overvoltage is probably the problem. This unit was bought by an owner that did not know the difference or importane of voltage. The owner has the machine installed in a building that has 240v, 3ph. Last...
With new cable and correct commissioning chart, I consistently get P3000 fault. And the new download rom Seimens has the chart for codes. I am checking the conditions that are listed for the 3000 code.
I did not bring log book home last night and dont have intrnet access at the location. The machine is new sino orgin. The machine has two units. one for each motor. I cant remember the faults that I get after unsuccesssful "reset," procedures. I have tried the three setup programs. Basic...
Search for skiving tools. Actually, the skiving cutting action and tool orientation to stock, has been the original cutting method since the discovery of cutting wood.
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.