Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Largest Manufacturing Technology Community on the Web
Stay Connected:
Recent content by no704
-
N
Clip thing what's it called and where to buy?
LOL, thanks for the laugh Doozer! I will do just that. Was trying to find something off the shelf. Thanks, -
N
Clip thing what's it called and where to buy?
like this but it has another leg 90 degrees off to engage a hole. I know I have seen them before, but can't think of where? -
N
6913 clausing lathe parts for sale
Have a 5C draw tube?- no704
- Post #12
- Forum: Tooling, Parts and Accessories For Sale or Wanted
-
N
Bandsaw Coolant Pump
Coolant pump in my Victor Horizontal bandsaw crapped out. It was a Graymills 1/8hp 230V 3Ph. They are really proud of these. Found an AMT pump on Amazon for ALOT less $$ with the same specs, and appears to be USA made. Anybody use these pumps? Thanks, -
N
Where to get small Titanium tube?
Titanium Joe's stuff is too big. Found Stahmann, another Chinese company as above. Why can't companies just publish their catalog and not need a special quote for everything? Thanks, -
N
Where to get small Titanium tube?
like capillary tube. Around 0.4mm ID. All I have been able to find is direct from China and takes forever to get, if it's even real. Thanks, -
N
New guy Sony DRO question / advice
I have a couple ToAuto DROs that were quite affordable and work well. -
N
2" annular cutter going partway through material
Try drilling some small holes in your cut. -
N
Shop Pet Peeves
Any one using an abrasive tool (like an angle grinder) in my shop! that shit gets every where! Take it outside! -
N
sealing new sight gauge in compressor crankcase?
Permatex Aviation Sealer -
N
DC power supply suggestions
had a 12V 100A supply at a previous employer, that thing could light you up! Found a new respect for 12V. -
N
OT LED tail lights
I put LED tail lights on my 1959 dodge. As stated, not enough draw to trip the flasher. I ran a relay off the lighting circuit and powered the leds thru that, worked fine. -
N
How Do I Hold This??
5N Aluminum Tube 0,050" Wall cast tube. How do I hold onto it for finishing operations without crushing it or "sizing" it smaller? Even in a 5C collet it seems to get smushed down, I need it to be a pretty tight sliding fit inside another tube. Pair of scissors handle in photo for scale... -
N
OT: guys with tyoe 2 diabetes, monitoring
Wife used to use the Libre one, has switched to Dexcom. The real time monitoring via bluetooh is nice, you can set high/low alarms, and you don't have to scan it. I even get alerts on my phone when she gets an alarm. -
N
3D Wax Printing for Investment Casting
I've been doing lost PLA casting for a bit. Using an investment plaster meant for gold and silver casting. Works well, important to have a vacuum chamber to put the mold in after pouring the plaster. PLA burns out clean.