Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Largest Manufacturing Technology Community on the Web
Stay Connected:
SAF's latest activity
-
Solder has several issues. 1) it is very soft, and the screw has no definite" stopping point" when tightening. 2) Solder experiences... -
SAF replied to the thread Enco mill camover switch replacement help!.Please let us know how it works for you, once you get it installed.
-
SAF replied to the thread Enco mill camover switch replacement help!.https://www.ebay.com/sch/i.html?_from=R40&_nkw=hz5b-10%2Ft21&_sacat=0
-
-
SAF replied to the thread Enco mill camover switch replacement help!.make sure you take good pictures of the wiring tags and labels before disconnecting things, you will certainly need them later.
-
SAF replied to the thread Enco mill camover switch replacement help!.I took a cursory look for you at Salzer, they make hundreds of cam switch models. I don't have the information to verify what you have...
-
-
SAF replied to the thread Induction Motor - 110V, 60Cycle, 3Phase, FL=16.4A HELP.If you have an available 240V 3Φ source, you can derive a 110V 3Φ output using two single phase 4 winding standard transformers, in an...
-
SAF replied to the thread 15 hp vfd for 5 hp motor on compressor.4-1-1 Leave sufficient space around the inverter. Measure the temperature in a position about 5 cm from the bottom-center point of the...
-
-
SAF replied to the thread 15 hp vfd for 5 hp motor on compressor.Sounds like another cap cooking shoehorn fit.
-
I am doing another VFD install with the WJ-C1-110LFU2 derated for single phase input running a 10Hp motor, I will use a DC choke 40-50A...
-
SAF replied to the thread American rotary ADX-60 high amperage on idle?.Can you post the tag on the transformer that you used to reduce the voltage? Wye transformers don't always play nice with an center...
-
SAF replied to the thread Rotary phase converter rotor problems.Couple of questions for you. How did your motor shop advise you to field test a 40HP Rotor? How did you get high and low readings on...
-
Drum switch perhaps?
-
I would leave the capacitor bleed resistor as is, the capacitors will discharge more slowly running the display/control circuitry. This...
-
SAF replied to the thread Compressor on VFD - has anybody actually done it?.I Believe you are correct, in your thinking. A slow start is also a poor choice for a piston pump, they need to get up to speed quickly...
-
SAF replied to the thread 15 hp vfd for 5 hp motor on compressor.Stuffing that big drive into a little shoe box that small is not doing it any favors, AB makes good equipment but you need to follow the...
