Disposing of horizontal milling cutters.
I have a lot of HSS horizontal milling cutter from slitting saws to side and face cutters accumulated over the years. Do they have any value other than scrap price?
These would cost a lot to buy new but so few people seem to use them do I just have to accept they will go for scrap?
I also have sets of Coventry dies and thread rolls, all inperial (inch/ whitworth UNC etc) - same problem- are they just scrap?
I have a lot of HSS horizontal milling cutter from slitting saws to side and face cutters accumulated over the years. Do they have any value other than scrap price?
These would cost a lot to buy new but so few people seem to use them do I just have to accept they will go for scrap?
I also have sets of Coventry dies and thread rolls, all inperial (inch/ whitworth UNC etc) - same problem- are they just scrap?