Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Largest Manufacturing Technology Community on the Web
Stay Connected:
Recent content by Scott Wayne
-
S
Part off coolant pouring out of the parts catcher
That’s not a bad idea either. It wouldn’t add much to the cycle time.- Scott Wayne
- Post #5
- Forum: Haas
-
S
Part off coolant pouring out of the parts catcher
That might just be crazy enough to work, thank you!- Scott Wayne
- Post #3
- Forum: Haas
-
S
Part off coolant pouring out of the parts catcher
Hey y’all, I’m having more issues with our Haas lathe bar feeder and parts catcher. No matter what combination of coolant tips I try, or orientation, I can’t keep the coolant from pouring down the parts catcher shoot and subsequently all over the floor. We have a hole cut in the bottom of the...- Scott Wayne
- Thread
- Replies: 6
- Forum: Haas
-
S
Haas servo bar 300 not pushing correct length
On the classic Haas controls it’s under parameters, then system, and “push rate” is 323. I had to go back and level the bar feeder a little bit better because the setup guys didn’t do a great job, the push bar would rub the spindle liner at the end of its reach, but it’s good to go now.- Scott Wayne
- Post #5
- Forum: CNC Machining
-
S
Haas servo bar 300 not pushing correct length
Right now it looks like ours is set to 100,000 in the parameters. What did you set yours too?- Scott Wayne
- Post #3
- Forum: CNC Machining
-
S
Haas servo bar 300 not pushing correct length
Hey everyone. I’ve been searching for answers for this and haven’t found anyone with my exact problem, or any answers that work. We have a Haas ST 30y and a Servo bar 300 at work. We set it up once and ran 150 good parts. I broke it down for the next job and now I’m getting incorrect push...- Scott Wayne
- Thread
- Replies: 20
- Forum: CNC Machining