Hi!
I read your thread on "Emergency switch error on Emcoturn 320 Fanuc OTC" and am having the same problems as you did, but on an Emcoturn 340 with sinumerik 810.
Did you get it going again with a jumper in the bar feeder connector?
(Is it a 24-pole conn on your machine too?)
In that case, which poles did you jumper?
As you said, Emco is a "bit" hard to get hold of (here in Sweden too!) when you want support on older machines....
Thanks for your time and best regards,
//Uffe
I read your thread on "Emergency switch error on Emcoturn 320 Fanuc OTC" and am having the same problems as you did, but on an Emcoturn 340 with sinumerik 810.
Did you get it going again with a jumper in the bar feeder connector?
(Is it a 24-pole conn on your machine too?)
In that case, which poles did you jumper?
As you said, Emco is a "bit" hard to get hold of (here in Sweden too!) when you want support on older machines....
Thanks for your time and best regards,
//Uffe