Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Largest Manufacturing Technology Community on the Web
Stay Connected:
stoneaxe's latest activity
-
Sstoneaxe replied to the thread SWJCR 8-01 toolholder and 20 inserts.Looks like the inserts are all left hand?
-
Sstoneaxe replied to the thread Re-conditioning a big European shaper-spindle molder.Did not replace the bearings, just used Kublers recommendation and forced the old grease out. Or think I did, can't tell without pulling...
-
Sstoneaxe replied to the thread Re-conditioning a big European shaper-spindle molder.Finally took the time to make this EMA my main profiling shaper with outfeed and infeed rests- takes two 4 1/2" x 2" carbide insert...
-
Sstoneaxe posted the thread Can a rough running RPC cause the three phase machine to run rough? in Transformers, Phase Converters and VFD.We have an older RPC (20 years)and the bearings are needing to be replaced. The machine this powers seems to be vibrating more than it...
-
Sstoneaxe replied to the thread Can a fuse degrade over time?.Thinking about it, the shaper did not always start exactly the same. Sometimes it just instantly started up, and sometimes it would...
-
Sstoneaxe replied to the thread Can a fuse degrade over time?.OK- you guys are freaking well of knowledge! Thanks! I will assume that the fuse was likely degraded over time and use, and replace...
-
SI am running a 9hp three phase shaper and just blew a fuse on startup- there is a disconnect switch with three 30 amp time delay fuses...
-
Sstoneaxe replied to the thread Well crap - I am ordering a SawStop tomorrow. (Mildly graphic pictures).I paid full price for mine from my wood supplier, but they did stick it on a truck with tailgate and drop it off for free.