Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Largest Manufacturing Technology Community on the Web
Stay Connected:
woodguy2's latest activity
-
Wwoodguy2 replied to the thread rfq-machined aluminum bars.Thanks to those who replied. My concept for aluminum was wrong here, and though a few were willing to do the machining for very low...
-
Wwoodguy2 replied to the thread Nylon or acetal gears to replace baltic birch known to work.
-
-
Wwoodguy2 replied to the thread Nylon or acetal gears to replace baltic birch known to work.After lots of communication with 3d printer services it looks like I could get someone to 3d print these in quantity (100 units worth)...
-
Wwoodguy2 replied to the thread getting a snug fit end tapping aluminum extrusion.Thanks for these replies. I think the 14-20 tap may well work. Never knew they existed! I can also perhaps make the part from 3d printed...
-
WI'm end tapping 2020 (20 mm square section) aluminum extrusion with 1/4-20 threads, and I want to hold the screw like a nylok nut...
-
Wwoodguy2 reacted to Finegrain's post in the thread Nylon or acetal gears to replace baltic birch known to work with
Like.
Here's my 2 cents ... OP has a very unique and apparently successful product. It is marketed to, and appeals to woodworkers. It's made... -
Wwoodguy2 replied to the thread Nylon or acetal gears to replace baltic birch known to work.Wow, thanks! this is a lot of information and many opinions to take in. I've learned a lot from these many replies. The current...
-
Wwoodguy2 replied to the thread Nylon or acetal gears to replace baltic birch known to work.Thanks for these replies. I'm looking for more than a few....used in sets of 7, and I'd order 100-200 sets at a time.I haven't found...
-
WI make a light duty woodworking power feeder from mostly baltic birch and hardwood. I know most potential customers are turned off by...
-
Wwoodguy2 replied to the thread rfq-machined aluminum bars.Thanks for the suggestion...I"m near Greenfield MA.
-
WI'm looking to redesign a small woodworking power feeder I currently make from predominantly baltic birch plywood, powered by a cordless...
-
Wwoodguy2 reacted to BHolcombe's post in the thread Well crap - I am ordering a SawStop tomorrow. (Mildly graphic pictures) with Like.
That's pretty slick. I have a small Comatic feeder on my router table and another on my bandsaw that is a dedicated bandsaw feeder...
-
Wwoodguy2 replied to the thread Well crap - I am ordering a SawStop tomorrow. (Mildly graphic pictures).The feeder is light duty for the table saw, no doubt. It can be used in conjunction with Jessem hold downs on the same track, which is...
-
Wwoodguy2 replied to the thread Well crap - I am ordering a SawStop tomorrow. (Mildly graphic pictures).Just read through this sobering thread. I've been hard contemplating the decision to replace my trusty Powermatic 66 as I know I don't...
-
Wwoodguy2 replied to the thread adding a knob to a standard extrusion between slots."You (well, your customers) will definitely appreciate a steel thread insert for anything threaded that gets regularly fastened and...
-
