What's new

Search results

  1. T

    Milltronics vm17 software estop

    Thanks for the reply. I think it may be time to call milltronics on this one as I’m in way over my head but thanks for helping
  2. T

    Milltronics vm17 software estop

    Okay thanks again for all your help!
  3. T

    Milltronics vm17 software estop

    Okay so tried that but still nothing. I did notice that the dc power supply said low power or something like that. I will send a picture of it. Could this have something to do with it? Thanks for the info on homing though. That’s good information to know
  4. T

    Milltronics vm17 software estop

    Thank you for the reply! I do understand it’s an older machine which is the only reason I have it lol. I will try holding the reset while jogging. Don’t think I tried that? I am just a weekend warrior at best and have taught myself what little i know so far but this is way over my head so I...
  5. T

    Milltronics vm17 software estop

    Hello I have a vm17 with centurion 6 controls. The problem I’m having is the machine is stuck in software estop mode. The readout shows that the z axis is minus when the z axis is all the way up. It should read plus when the axis is up. Also the big vfd says external fault. I thought the encoder...
  6. T

    Milltronics vm17 software estop

    Hello I have a vm17 with centurion 6 controls. The problem I’m having is the machine is stuck in software estop mode. The readout shows that the z axis is minus when the z axis is all the way up. It should read plus when the axis is up. Also the big vfd says external fault. I thought the encoder...
  7. T

    #3 involuted cutter

    Hello again. I just realized I spelled involuted wrong. My apologies. I got the cutters at an auction several years ago. I’m not sure any two of them are the same maker lol. I do have a couple of pictures of it but haven’t figured out how to post them yet. I will post when I figure out how...
  8. T

    #3 involuted cutter

    Ok. Thanks so much for the information.
  9. T

    #3 involuted cutter

    Hello I have a # 3 involuted gear cutter that doesn’t have any depth of cut markings on it. All it says is no3-16p. 35 to 54 t. Does .134 sound like the correct depth? This is only the second time I’ve cut a gear and the first time it was stamped into the cutter. I know what all the other...
  10. T

    Rockwell 11" (?) follower rest

    Rockwell 11” follow rest Hello This is probably a silly question but do you by chance still have the follow rest for the Rockwell 11”?
Back
Top