What's new

Search results

  1. B

    Servo Dynamics 1525 Voltage Regulator

    This is something I had not considered. Thanks!
  2. B

    Servo Dynamics 1525 Voltage Regulator

    It seems to happen randomly during a cut. One day I got 150 cycles out of the mill the next I can hardly go 10 cycle without the drive dropping out. It doesn't seem to be related to temperature. Almost never during rapid moves. The X axis does it more sometimes only setting off that drives...
  3. B

    Servo Dynamics 1525 Voltage Regulator

    The fuses are intact and the resistor is in the 10 ohm range the drive manual specifies. The regulator is keeping the voltage in the proper range but I was thinking there could be some spike that sets off the error that is too quick to detect with my voltage meter.
  4. B

    Servo Dynamics 1525 Voltage Regulator

    My mill has 3 Servo Dynamics 1525-10 drive boards that randomly get voltage errors and shut down. The voltage LED is for overvoltage and undervoltage conditions. After trying high and low input voltages within the specified range I'm suspecting is a momentary overvoltage and the shunt...
  5. B

    Allen Bradley 8400 Circular Pocket G26 Canned Cycle

    I have a CNC mill with a AB 8400 control. I'm trying to use the G26 canned pocket milling cycle to make a circular pocket. The manual says you need to leave the X,Y coordinates blank and the mill will make a pocket 2 times the R (radius) dimension. I get the error "Radius Too Large". Tried...
  6. B

    Mini Boring Bar CHNC I

    I'm trying to machine a bullet shaped cavity about .224" wide by .350" deep. My boring bar is .077" wide but hits the opposite side of the cut as the lathe backs off after roughing cuts. I'm starting with a .080" through hole. I'm using a Hardinge CHNC I with a 810T controller. The lathe...
  7. B

    D10 Manuals

    Here are PDF copies of the manuals for the E10 sinker and P25 generator. D10- spark erosion machine.pdf - 2 MB D10- spark erosion machine D10- spark erosion machine-part2.pdf - 3 MB D10- spark erosion machine-part2 isopulse generator P25.pdf - 653 KB isopulse generator P25 P25...
  8. B

    D10 Manuals

    Can someone with some experience on this machine tell me what each switch is for and how to use some of the settings? So far I get that the three large switches are for power, coolant pump, and hydraulic pump.
  9. B

    Hi Bob, wondering if you still have any of the manuals for a Charmilles D10 sinker EDM? Could I...

    Hi Bob, wondering if you still have any of the manuals for a Charmilles D10 sinker EDM? Could I get a copy from you? Thanks in advance!
  10. B

    D10 Manuals

    I need a manual too. I just picked up a Charmilles D10 last week. Any instructions would be much appreciated.
Top