My mill has 3 Servo Dynamics 1525-10 drive boards that randomly get voltage errors and shut down. The voltage LED is for overvoltage and undervoltage conditions. After trying high and low input voltages within the specified range I'm suspecting is a momentary overvoltage and the shunt...
I have a CNC mill with a AB 8400 control. I'm trying to use the G26 canned pocket milling cycle to make a circular pocket. The manual says you need to leave the X,Y coordinates blank and the mill will make a pocket 2 times the R (radius) dimension. I get the error "Radius Too Large". Tried...
I'm trying to machine a bullet shaped cavity about .224" wide by .350" deep. My boring bar is .077" wide but hits the opposite side of the cut as the lathe backs off after roughing cuts. I'm starting with a .080" through hole. I'm using a Hardinge CHNC I with a 810T controller.
The lathe...
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.