This is a D22 VAC drive, OSP 5020L control, 1993 model machine.
Control gives 110 Alarm A SDU -1, immediately after booting.
This has been an intermittent issue since I acquired the machine about 18 months ago. Up to this point, the reset button on the VAC board has cured the problem, but...
Looking for a couple large angle plates for a HBM. The Y axis on it is 48", so anything in that height range would work. Probably 36" minimum, and 60" maximum tall.
I think a pair of them about 24-30" wide, and roughly 24-30" deep would be ideal.
Welded or cast is fine.
My cost for 2x new...
This was PM member ewlsey's machine that he put quite a bit of work into:
https://www.practicalmachinist.com/vb/machinery-for-sale-or-wanted/fs-tree-vmc-1260-machining-center-333340/
Machine still looks the same, I haven't done much to it other than replace the Z axis way cover. I think I...
Everyone says dont quit your day job until you have some steady work and savings built up. I've ditched the day job for about a year now, and work is steady enough. Savings.... well that gets converted to tooling at a 1.5:1 (in their favor) ratio seems like.
I've been positioning myself as the...
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.