I was cross drilling a 13/64" hole in the 7/8" diameter Pin on the tow bar I use to flat tow the Bronco.
Anyway, I used poor technique, the hole got hot, I heard a SQUEEAK and the drill stopped drilling.
I have purchased a 13/64 solid carbide drill.
My questions are: What RPM should I spin the...
Okay I have a need to modify qty 1 of a 4 inch PVC Elbow fitting.
Fittings are all designed to work with Schedule 40 wall thickness pipe.
For this application I am using thin walled pipe and I need the ID of the fitting to be opened up about .18 inches. What tool will work around the inside of...
I found a piece amongst the tooling for my South Bend Heavy 10. It is too large to fit it.
It looks like the clamp that goes underneath the ways to lock either a tail stock or steady rest in place.
This one has a stud threaded into it.
There are two sets of marking on the part. SR on one...
I am looking for a latch and knob assembly for a 1943 SB Heavy 10 lathe.
It has the cabinet with U shaped legs and 3 drawers on the right.
One drawer has no latch.
The latch has a number stamped on the inside. Does anybody know if this is the latch part number or possibly the tumbler number...
I have a dividing head of unknown origin. I'd like to learn more about it and determine what if anything I am missing.
First there are no markings on any parts except the one dividing plate has Pat. Pen. stamped into it.
The body is cast in aluminum as is the dividing plate.
Center height is...
Can someone with a Heavy 10 make some measurements for me?
Handwheel diameter:
Handwheel Thickness.
Sleeve that hand wheel bolts to.
Od where handwheel mounts.
Od at opposite end from handwheel.
Rotating nose piece:
Diameter where nose chamfer begins: (large end of chamfer)
Length
Thanks...
I have a 1943 toolroom Heavy 10.
It is equipped with the large end cover with a plate describing which gears are required to cut which metric gears.
I have no extra loose gears.
Also the banjo on my lathe is just a straight piece. I have seen pictures of other banjos that are Y shaped. But...
Hello all, this is my first post. I hope I am placing this in the correct subforum.
I have the above mentioned mill. My wife's grandfather bought in new in Feb. 1957. Serial # is MV175
I have had the beast for nigh on twenty years but I have not used it a lot. Something about raising...
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.