I just checked it is a 110 volt coil. The transformer has 4 wires. Two went to L2,L3 the other was wingut fastened to #1 wire from the on off switch, last wire was connected at the jump behind T1.
I ended up taking the leads out to the transformer for the light. Wired it up like the diagram in the box and it fired up. Now after about ten minutes on, I am getting smoke. The wiring in my building has a high leg on B.
Thank you for the reply.
I am not familiar with mag starters. This particular unit has a transformer for the light.
When start button is pushed I am getting a hum, but doesn’t engage. If I compress the magnet manually while the start button is engaged it seems as there is not enough pull to...
Hello, I was reading a thread on mag starters, and saw you had said you had papers and 100 line.
By chance did you work with the general electric cr106 b1?
I have 2 pettingell power hammers, each has the same.
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.