I have a 98 HS-1RP and while I was tracking down some leaks on the lub panel I mixed up some of the air lines. I had put tape on them and the corresponding fittings, however the oil that was all over everything allowed the tape to fall off. anyways I looked up the service manual for my machine...
Haas service manual pretty much says its related to the leaking counter balance. move the z axis to the top of travel, then look at the gauge on the hydraulic tank, better yet take a picture as straight on as you can. check it periodically. if the system is leaking, this would cause the problem...
I got one of the bellows back in place, the one that was badly warped. well the other one that wasnt warped got warped when it was sitting out side the machine. I tried putting it back in with a friend's help, and it wasnt lining up, we took it out to try to straighten the ribs, which was...
Just for sanity check if the control cabinet has the floppy installed, or the pendant, it can be in either location. If you do end up finding you have a floppy drive check parameter 209 to see if the floppy disk is enabled. if its not enable it. I replaced the floppy with a usb to floppy...
I plumbed the 80 gallon tank in and timed the pallet change for when the pressure was the highest, and it was able to do a pallet change. I also bit the bullet and ordered a replacement lower y axis bellows, and found a pair of sunon fans on amazon(prime) to replace the rusty?? ones in the...
I went to do a pallet change and Womp Womp, it wasnt able to change the pallets. I put an easier to read gauge on the air gun line that comes off the machine manifold, the air drops from 95 to 60 while trying to do the pallet change.
CALIFORNIA AIR TOOLS 20040SPCAD is the compressor I have...
we have 3 om2's at work. they were all bought new in 2006/2007. they ran 3 shifts plastic cutting until 2019. the mfg dept gave us one for making prototypes. I had the spindle and all linear guides and ball screws replaced. the spindle was the main issue. I also had the tech redo the grease...
I mean if you think about it, the umbrella is not able to move one tool from one spot to another, at least not without an empty tool pocket, so there really wouldn't be much point. brother speedio and fanuc robo drills work the same way, and they are very fast machines.
atx connectors on a pc are identical to the connectors haas uses. I snipped a male pin and wire out of a spar splitter and spliced it in place. spindle encoder error went away. z axis was having an intermittent grid error, used the procedure above to fix that. got the machine to power restart...
I had the same problem when I started up my new to me(abused by previous owner) hs-1. basically the limit switch was sticky and stuck down. the controller tells the axis to move away if the switch is stuck down. you can electrically test the switches with a multimeter.
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.