A very good and non-destructive device is the Krautkraemer Microdur M1.
It measures the hardness according to the UCI method, is portable and can be used anywhere without any problems.
The probe is calibrated on a reference sample of the material to be tested.
You then place the probe on the...
It also seems to be possible to crash the D11 with questionable program lines....
Sometimes I work on parts that have already gone through many stages of production. So that I don't cause any damage to these parts, which are now my responsibility, I install some break point lines in the program...
As with Bosch, the card is equipped with an optimization card, which the producer tuned to me perfectly according to the servo motors for X/Y and Z and taking the age of the motors into account.
Mr. Methfessel is also very friendly, helpful and approachable over the phone.
The black cover is a gigantic heat sink that is screwed to another massive aluminum block below the black surface.
The power transistors are therefore extremely well cooled.
It is the block in the background
I have attached the pictures of the cards from "msrtec" which Martin described above.
I installed my cards in a MIKRON WF3 DCM with Heidenhain TNC150.
They are of extremely high quality....but the prices for a set were also very high.
I needed them because the original BOSCH cards were causing...
If the module of the gear is known, perhaps you can purchase blanks here and machine the hub yourself
https://www.maedler.de/product/1643/stirnzahnraeder-zahnstangen-innenzahnkraenze-sperrraeder
The cards that come from a TR that I found cheaply on eBay. These are not the cards I purchased from the company mentioned above.
The pictures of these cards will follow in the next few days... because of Christmas
It looks as if market conditions have changed and the times when such „high-earning service providers„ had lucrative jobs are slowly coming to an end….
Translation:
Range of movement of the tool, mm: X (longitudinal) 1600, Y (vertical) 800, Z (transverse) 800.
Table, clamping surface 2000x 1000mm, drive power work spindle 18kW, speed range 63-3550 rpm, feeds dependent on control, programmable up to 4000mm/min, rapid traverse 10m/min.
Distance...
Yes, i have a brochure in which the DECKEL S500
machining center is described.
It is a brochure about all DECKEL milling and drilling machines.
Unfortunately only in German, but you can assign the technical data so well.
I probably overdid it a bit with M7 (additional lubricating impulse) in a program (thousands of G1 "tiny steps" from CAM) and emptied the slideway oil-container.
After the container was pumped out during the program run, the machine logically went into error (1101 and 1107)
I refilled the...
I put another chip in for demonstration. It's not immediately apparent when looking directly at the keyboard from above.
It's easier to see from this perspective.
And it actually blocks the whole keyboard so that no more inputs are possible...
After running a program, the vice was blown off with compressed air to clean it to insert a new raw material.
The mechanical probe was exchanged for the Z zero point and the Z axis was zeroed in the "Preset".
When the program, which had already run 22 times, was started again, the Z axis moved...
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.