What's new

Search results

  1. D

    Deckel FP5NC - G19*1 working at an angle

    Hello, Has anyone worked on parts while swiveling the head? The question I have is when the work is finished and it's time to return the head to its neutral position are there pins to "center" it or do I have to use a dial indicator to get it aligned with the flat table? Best regards
  2. D

    Deckel FP5NC - Maintenance

    Hello, 1. I am working on Deckel FP5NC (Dialog 4) and I noticed the machine is leaving a mark when doing a circle/arc. The mark is on both sides of the circle along the X-plane. I tried entering the circle on Y-plane but the mark is still there. The mark is about >0.01mm in size. I'm...
  3. D

    Dialog 4 - error 70

    Hello, I'm spinning in a circle and can't get out of it. Problem: I was sending G-code into Dialog 4. After the sending was done I switch from program BA14 on to BA9 an error occurred (error 70), pressed "?" typed N1, N2, N2, ...etc. to check if the code was there and everything looked OK...
Back
Top