hey big Tex!!
it certainly has been awhile. I just got done rebuilding the spindle on my index knee mill, $1500 angular spindle bearings brand new from eBay for $60!!
she’s running like a top.
also replaced the motor/step pulley bearings in the sb16, that was a real pain in the ass, after...
Hello all! Been awhile, does anyone have an idea on the tolerances for the southbend 16 bed ways from factory?
I have a few companies giving quotes for grinding my bed ways back to factory spec but they want to know what kind of tolerance I need.
frankly I can’t really answer that.
of...
Tracking and banning these accounts is an exercise in futility. Admin shouldn’t stop banning them but in reality they will make a new account within minutes and proceed to scam unfazed.
The best approach IMO is to put a sticky and banners/notices to educate and dissuade users from engaging...
I reckon men didn’t take many steps backwards in these old facilities, seeing as how you’d end up tangled in the ceiling rafters spinning to pieces.
Almost primal will to survive these types of work/conditions. Back when life was simple, “work *hard* or die”.
Wish I could help you out! It’s been over 10 years since I was in school with that lift. I don’t remember any issue with the steering and it was always kept indoors at room temp so it fired right up. It had the original LP engine.
All I really remember about it was the heavier the load the...
Fair enough, the “car guy” in me says you should of thrown a lumpy cam in her just for shits and giggles. I have a 4.3 out of a crashed 2000Ish Silverado siting on the shop floor for free to a good member. I pulled the nv3500 transmission for a 350 swapped sc300.
We had a 4.3 forklift in...
He said they were built different and he’s right, not that lathe technology was better back then, more along the lines of “times have changed”. You can indeed still buy new manual lathes but very few are quality built machines. Most are built in China to a price point out of inferior materials...
I have read about cracked Reservoirs that leak through the bottom, I don’t think the head bolts would typically pass into the reservoirs but anything is possible. I would definitely heed Tex’s advice and thread seal them anyway.
The gits will drain empty if the threads on the gits are not sealed, if the paper under the gits for wet then I would investigate both the head bolts and gits threads
Did these guys miss a commission from not selling that wrench to you? Sheesh, the man wants to make his own so let him be.
As a hobby guy I’ve literally grabbed junk out of my junk bin and turned/milled it down into smaller junk, I spent my time to buy experience and joy/relaxation/meditation...
Green Lee, no issues friend. We’re here of our own accord. You will definitely figure that beautiful beast out and get her making chips I am sure of it. No one is disappointed or mad at you friend.
“If your going through hell, keep on going”
Best of luck and let us know if there’s anything...
I’ve seen a lot of threads and did my own “investigations” into this issue.
Over on the Hudson forums (cars) the same thing happens, the electronics/PC forums, pretty much any forum that exists.
The scammer finds an AD posted by a member looking for “something” (machine/car parts/PC) and the...
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.