What's new

Search results

  1. A

    Advice on getting into a Lodge and Shipley 14" Model X apron?

    I'm attempting to take the apron off of my Lodge and Shipley Model X lathe. Taking the feed levers that resemble cow udders off of the apron exposes the shafts for the longitudinal and cross feed engagement. Around those shafts coming out of the apron are brass bushings with wider collars up...
  2. A

    Motor shaft questions

    I have a pedestal buffer and I think I need to make a new shaft for it because it wants to walk across the floor even with no wheel on the shaft. One end of the 1" shaft has a .0005" runout and the other end has a .0015" runout. If I make a new shaft out of 4140 should I start with annealed or...
  3. A

    Information to make gears for metric threading for Lodge & Shipley 14" Model X?

    Does anyone have the information to be able to make the proper gears for metric threading? I checked with Monarch and the cost was too much for me. The manual specifies the gears needed with respect to the number of teeth for both the change gears and the two "drivetrain" gears. The attached...
  4. A

    Gears for Lodge & Shipley 14" Model X for metric threading?

    Does anyone have the gear set for a Lodge & Shipley 14" Model X for Metric threading? Allen
  5. A

    Geometric die heads and a MT4 tailstock

    I've got three geometric die heads that I've picked up. In the videos I've watched most are having the die head pull the tail stock into the carriage to release the dies from the workpiece. In the videos I've seen the tailstocks are not very big and I'd like to know if anyone is using a die...
Back
Top