What's new

Search results

  1. J

    LD Laser Machines - 80KW insanity

    I have a waterjet business, I have been drooling over these lasers, Obvious downsides with a Chinese machine being parts and support but holy shit the speed and power of these things. - I wonder what the power requirements look like. Are there any north american manufactures getting anywhere...
  2. J

    Maxcut CNC Machines?

    Anyone here used Maxcut CNC machines? My understanding is that they originate from Buffalo Manufacturing in Taiwan. Specifically I am looking at a used MCV-1100, its a 40"x20" travel machine, Cat 40, boxway, 10k spindle, Fanuc Control I can barely find any info on these machines anywhere, I...
  3. J

    Fadal 4020 reviving rigid tapping capabilities but running into spindle overload.

    I have a 1994 Fadal 4020HT with the 88HS control. As far as I can tell this machine left the factory with rigid tapping installed or it was installed later. It has the right puzzle pieces, wiring is there, encoder is there, rigid tapping spindle drive. The only missing piece is that there was a...
  4. J

    Fanuc 21-T dead rs232 comms

    Hello everyone I have a new to me Daewoo Lynx 200B lathe, I need some assistance in troubleshooting the RS232 Communications. The machine uses a Fanuc 21-T control. I would like to say I have tried absolutely everything under the sun to try and communicate with the machine but maybe I missed...
  5. J

    Confounding behavior when homing Daewoo Lynx Lathe

    I have a new to me 1998 Daewoo Lynx 200B Lathe with a Fanuc 21-t control. My issues are when I try to reference (home) the machine. The z axis works fine. If I am near the chuck, it rapids away until its about 3" from its home and creeps until it hits its reference (home) position then stops...
  6. J

    Baffled By Z offset changing between tool changes

    I have a Milltronics MB-20 cnc. - I am running a basic part and everything is going fine until I move to change to another tool - all other tool changes prior to this one were fine. N9024 is where the trouble happens, you can see the z offset suddenly shift. - what this results in is my next...
  7. J

    Stanko Smart Lathe

    I am curious if anyone here has seen this "new" design The lathe itself if infact made by Stanko is no doubt pretty solid and I like the simplicity of the repeatable actions. - Their HMI could use some polishing so that it doesn't look like it was designed by a toddler but it appears...
Back
Top