Hi, I'm trying to get an old Leadwell MCV-OP running with a Mitsubishi Meldas M3 control up and running. I think I've loaded a program into memory and maybe set G54, but I can't figure out how to start it. When I got the machine, it came with the Fanuc operator's manual, not the Mitsubishi one...
Looks like that procedure is for thw M0 control I have an M3 it doesn't line up with the screens I have and after finding an address 72 in the bit select menu messing with it did result in any different behavior.
Hi, I recently obtained a leadwell MCV-OP form 1993 with a mitsubishi meldas control that had a dead battery. I have replaced the battery, reset the control and re-entered the lost parameters from a hard copy the machine now can home, jog, and operate the spindle. But when I run a tool change...
Bob, I appreciate the feedback I looked over the prints and realized I forgot some position callouts and should add a general finish callout on the prints else everything else should fall under the general profile callout. If you don't mind me asking, what is a good general tolerance you can...
Looking for someone willing to make 3 small parts on a wire EMD for a prototype I'm building. Two of the parts have 0.010 internal radii, two are made from brass the other is 304 stainless.
Tolerance: +/- 0.005" general profile some areas require +/- 0.0002".
Anyone interested, please PM me...
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.