Here's another tip, I recently discovered a few months ago.Thanks again for this Marvel. I just read and re-read everything to fully digest it. All really helpful info. I love the tip about using the shift key with simulations.
Programming multiple setups in part mode is how I originally learned. I just find it easier to manage a separate config for each OP.
What did the post processors cost from your reseller? I know I don't really need to use subs for 3-4 part runs with the new Haas controller as it can handle the larger code just would like to know how to use subroutines. There will come a time where I'll be programming for 16-20 part pallets and it might come in handy then.
In the CAMWorks Tool Tree, you can drag and drop operations from tool to tool, rather than going into each individual operation and selecting the tool.