What's new
What's new

Bridgeport clone spindle encoder

Joined
Dec 12, 2023
Hi there. I have turned an old Bridgeport mill from the 80’s that used to run with a cassette tape, into a modern centroid cnc.
I have tried to wrap my head around how to setup some hardware to act as a spindle encoder. My centroid acorn controller can monitor 1 encoder but I don’t know where to install an encoder that can reliably control the spindle speed. This is so I can unlock my rigid tapping ability. Any suggestions? Thanks for reading this if you have made it this far!IMG_5030.jpeg
 

Attachments

  • IMG_5029.jpeg
    IMG_5029.jpeg
    1.4 MB · Views: 5
  • IMG_5030.jpeg
    IMG_5030.jpeg
    1.5 MB · Views: 5








 
Back
Top