Hi All,
I have a Bridgeport Clone I'm going to retrofit. Not here to discuss the morals of that decision, but I have some question about swapping the spindle to a NT30 for repeatability. They have a lot of those for sale on ebay and I was wondering if anyone has heard anything about them. I was going to just but the bare spindle then get good bearings elsewhere.
Thoughts and opinions?
Also, for this conversion, I'm going to Z axis the knee and leave the quill manual. Any idea who makes a Z axis ballscrew kit?
Thanks
Aaron
I have a Bridgeport Clone I'm going to retrofit. Not here to discuss the morals of that decision, but I have some question about swapping the spindle to a NT30 for repeatability. They have a lot of those for sale on ebay and I was wondering if anyone has heard anything about them. I was going to just but the bare spindle then get good bearings elsewhere.
Thoughts and opinions?
Also, for this conversion, I'm going to Z axis the knee and leave the quill manual. Any idea who makes a Z axis ballscrew kit?
Thanks
Aaron