Hi all friends
I hope anyone can guide me here about C axis.I have a Takang TNC-20N with Fanuc OTC controller.when i start work on it no parameters was there in the machine i have all books diagrame and parameters wite but bad luck no 900 was in the book so i get same Machine 900 parameters and put all diagnostic put also.My machine has C axis but the 900 where i get not have C axis this time no alarm on the machine and X and Z axis goes to refrence return ok spindle working fine but when i choos for C axis to go zero brake work and it stuck little bit noise for move but brake not released that's why not perform zero position of C this is C is for spindle rotating on 360 degree the machine is not showing C on display can any one help me please very greafull to you all
I hope anyone can guide me here about C axis.I have a Takang TNC-20N with Fanuc OTC controller.when i start work on it no parameters was there in the machine i have all books diagrame and parameters wite but bad luck no 900 was in the book so i get same Machine 900 parameters and put all diagnostic put also.My machine has C axis but the 900 where i get not have C axis this time no alarm on the machine and X and Z axis goes to refrence return ok spindle working fine but when i choos for C axis to go zero brake work and it stuck little bit noise for move but brake not released that's why not perform zero position of C this is C is for spindle rotating on 360 degree the machine is not showing C on display can any one help me please very greafull to you all