What's new
What's new

Carbide endmills 1/4" and 3/8"

Any Left and I would like 30 - 1/4" half flat/ half not flat, if you can get that many in a small flat rate box.
Thank you!
George
 
Any Left and I would like 30 - 1/4" half flat/ half not flat, if you can get that many in a small flat rate box.
Thank you!
George

Still a lot of 1/4" flat, very little of others. There are 16 of the 1/4" carbide end mills in a pound, I can probably fit 100 (6.25 lbs) in a small flat rate box. To be on the safe side, order only 1/4" flat and depending on the amount you order, I'll throw in a variety of what I still have for no charge.
 
Received mine today
More than satisfied.

Thank you Bluechpx for what you've done providing these end mills at a basement price and the bonus extras!
 
My shipment arrived all chipped and broken ... exactly as ordered.
The chipped and broken pieces will be good for various projects.
Perhaps I don't make enough broken end mills myself. ;)

I am amazed that so much mass could fit in a small flat rate box
and not burst out. But all was OK.
 
My shipment arrived all chipped and broken ... exactly as ordered.
The chipped and broken pieces will be good for various projects.
Perhaps I don't make enough broken end mills myself. ;)

I am amazed that so much mass could fit in a small flat rate box
and not burst out. But all was OK.
Hi bluechipx

If you still have any chipped/broken ones, I'd also be interested in a box of those...

Best regards,

Lee



Sent from my SM-N960U using Tapatalk
 








 
Back
Top