Cincinnati toolmaster MT power feed

[NMRKen]

I am going to look at a toolmaster mill (1973 build) for a very good price (asking 1600!), one issue is it appears to not have any power feeds. Does anyone make an aftermarket power feed for this mill? I have done some looking but hove not located anything.

 

[tnmgcarbide]

those later french toolmasters are more like a rambaudi than a 1-d . a servo type won't do it.

a shizouka or rambaudi PF could possibly be adapted- but then where would you possibly find them either ... and would cost more than the $1600 mill if you could...