steamandsteel
Aluminum
- Joined
- Oct 21, 2017
- Location
- Wichita, KS
Hello,
I am looking to fix a few issues on my Cincinnati.
Power feeds work. They are powered off a separate motor on the left side of the knee (from standing in front of the machine)
However, they don't work well. My rapid traverse lever is stuck and the machine is therefore stuck in rapid traverse mode. Y and Z axes work fine, but the X axis lever will not engage at all, and grinds/buzzes gears when you try to.
Any ideas on how to free up the rapid traverse lever, and fix the X axis?
Attached below are some pictures:
I am looking to fix a few issues on my Cincinnati.
Power feeds work. They are powered off a separate motor on the left side of the knee (from standing in front of the machine)
However, they don't work well. My rapid traverse lever is stuck and the machine is therefore stuck in rapid traverse mode. Y and Z axes work fine, but the X axis lever will not engage at all, and grinds/buzzes gears when you try to.
Any ideas on how to free up the rapid traverse lever, and fix the X axis?
Attached below are some pictures: