Creating a point at the intersection of 2 lines in Mastercam 2022

[implmex]

Hi All:
A quick question for all you Mastercam drivers:
I'm having a helluva time trying to place a point where two lines would intersect if they were longer.
It was easy to do in the old Mastercam I'm used to, but I can't figure out how to do it in Mastercam 2022.
The help utility is useless, Google is useless too, so I'm stuck.
I resorted to just extending the lines until they intersected, putting my point there and then trimming the lines back again, but that's a really stupid way to have to do it.

Surely they did not kill that function and I just can't find it in the new GUI.
Would they really kill something so basic and useful?
Would they??

Cheers

Marcus
Implant Mechanix • Design & Innovation > HOME
Vancouver Wire EDM -- Wire EDM Machining

 

[Mtndew]

Click on "Point Position" then hit the i key for intersection and click the 2 lines.


Same goes for Endpoint,Midpoint, etc... Hotkeys E and M respectively.

 

[implmex]

Hi Mtndew:
I tried it.
It WORKED!!
Now I owe you forever.

Cheers

Marcus
Implant Mechanix • Design & Innovation > HOME
Vancouver Wire EDM -- Wire EDM Machining