DMG-MORI NHX4000 tool setter

[cncwhiz]

Anybody have any troubleshooting and or documentation for the jack in the box tool setter? The machine runs good but we are always having problems with the tool setter. I am activating a call. Te lid opens up and it pops up. It is never getting the up completion signal. I can't find where to adjust the switch. I am going to got out to the shop and see if I can pull it out of the housing in the table.

 

[Orange Vise]

The limit switch is deep in the post. You'll have to [carefully] pull the whole thing out to access it.

Has the toolsetter been crashed?