Froneck
Titanium
- Joined
- Dec 4, 2010
- Location
- McClure, PA 17059
I need to locate the edge of 2" diameter "washer" 17/32" thick. Actually it starts as a machined "washer" 1-3/8" ID X 2" OD X 17/32" thick. Then cut int 4 sections. Ends are milled so they are parallel and perpendicular to cord dimension .915" I then have to put a 4.2mm hole parallel with the cord so that the side .040 away from the ID. ID and OD are machined to within .001" so I can locate ID using the OD. I have Starrett 828 "wiggler" and 827A edge finder. (actually all the Starrett 827 series) Problem is locating the exact center of the OD. I have a B&S 1/2 X 1/2" but don't want to use 1/2" chuck plus being the width of the part is 17/32" and is between the jaws of a Kurt vise. I did find a 10mm X 10mm B&S on ebay but it's taking forever to be delivered, I paid for it 11/8, delivery is supposed to be 11/17 but tracking states it hasn't been picked-up yet!
I measured the diameter of the 828 .100 edge finder rod and it also is .100" Can I use the rod to edge find rather than the small .100" end until the B&S 10mm edge finder arrives?
I measured the diameter of the 828 .100 edge finder rod and it also is .100" Can I use the rod to edge find rather than the small .100" end until the B&S 10mm edge finder arrives?