sam_stlouis
Cast Iron
- Joined
- Aug 1, 2010
- Location
- missouri, USA
End mills I have 4 groups of end mills. Most all are new.
Group 1 and 2, the exact same just divided up. Might be a couple used. From 3mm up to 7/8, most are 4 flute, but a couple others are in there. Mostly Hss, but a few of the smaller ones are carbide. A mix of square cut, radius, and ball. These groups should cover most needs of a garage shop, so good for someone just starting to get most things at once. 80 shipped each group
Group 3, mostly new, but a few more used then other groups. A variety of flutes and ends, but a few more ball ends then other groups. 45 shipped.
Group 4 small ones. all new. These are also in groups 1 and 2. 1- Promax carbide 5 flute 1/2”, 2-hertel 5/16 4 flute, Hss. 2- guhring, 3mm carbide. 1-5/32 2 flute Hss. 50 shipped
1 group of misc reamers, mostly used. The ones in packages are new straight flute drills. 30 shipped
Group 1 and 2, the exact same just divided up. Might be a couple used. From 3mm up to 7/8, most are 4 flute, but a couple others are in there. Mostly Hss, but a few of the smaller ones are carbide. A mix of square cut, radius, and ball. These groups should cover most needs of a garage shop, so good for someone just starting to get most things at once. 80 shipped each group
Group 3, mostly new, but a few more used then other groups. A variety of flutes and ends, but a few more ball ends then other groups. 45 shipped.
Group 4 small ones. all new. These are also in groups 1 and 2. 1- Promax carbide 5 flute 1/2”, 2-hertel 5/16 4 flute, Hss. 2- guhring, 3mm carbide. 1-5/32 2 flute Hss. 50 shipped
1 group of misc reamers, mostly used. The ones in packages are new straight flute drills. 30 shipped